Vivotek FD8363 Manual do Utilizador

EN - 9EnglishBased on the live image retrieved from the camera, adjust the camera lens by doing the following:To adjust the viewing angle -- 3-axis me

EN - 101. Attach the dome cover to the camera by combining it to the retainer and aligning with the mounting holes.2. Secure the four dome screws with

EN - 1EnglishPower off the Network Camera as soon as smoke or unusual odors are detected.Refer to your user's manual for the operating temperatur

EN - 2IR LEDs (8 units, effective up to 15m)Physical Description2Inner ViewVari-focal LensTilt Adjustment ScrewBlack Cover1. There is no internal micr

EN - 3EnglishFirst, use the included T20 hex key wrench to loosen the four screws and detach the dome cover from the camera base. Follow the steps bel

EN - 4Connect power lines and if you have external devices such as sensors and alarms, make the connection from the general I/O terminal block.8765432

EN - 5English21RJ45 Cable Dimension (unit: mm)2. Strip part of the sheath from the Ethernet cable.1. Drill a hole on the rubber seal plug and insert a

EN - 6123A4BMounting the Camera1. Attach the supplied alignment sticker to the wall.2. Using the circle marks on the sticker, drill at least 2 pilot h

EN - 7EnglishNetwork Deployment41. Connect RJ45 Ethernet cable to a switch. 2. Connect the AC cables from the terminal block as an alternate power s

EN - 81. Install “Installation Wizard 2” from the Software Utility directory on the software CD.2. The program will conduct an analysis of your netw