Vivotek PZ7132 Guia de Instalação Página 1

Quick Installation GuideThis guide describes the basic functions of PZ7131/PZ7132All detailed information is described in the user's manual.PZ713

EN - 9EnglishFor further setup, please refer to user's manual on the software CD.Ready to Use61. Access to the Network Camera from the Internet.2

EN - 10Note:1. SSID, abbreviated from Service Set Identifier, is the name assigned to the wireless network. The PZ7132's factory SSID setting is

P/N:625007900G

EN - 1EnglishContact your distributor when such cases happen.Keep the Network Camera away from water. If the Network Camera is wet, power off immediat

EN - 2Do not place the Network Camera on unsteady surfaces.Do not touch the Network Camera when it's lightening.Do not disassemble the Network Ca

EN - 3EnglishAntenna (PZ7132 only)ScrewsPZ7131 / PZ7132Warranty cardPower adapterQuick installation guideSoftware CDCeiling mount bracketsPackage Cont

EN - 4Front panelBack panelBuilt-in microphoneStatus LEDLensMic. In12VDCEthernet Ext. I/OExt. Int.AudioOutIndented reset buttonEthernet 10/100 RJ45

EN - 5EnglishMounting the Network Camera1. Attach ceiling mount bracket A to the Network Camera and secure it with two small screws.2. Drill three pil

EN - 6Network Deployment4General Connection (without PoE)1. If you have external devices such as sensors and alarms, make connection from general I/O

EN - 7EnglishPower over Ethernet (PoE) (PZ7131 only)When using a non-PoE switchUse a PoE power injector (optional) to connect between the Network Came

EN - 80002D106659ERoHSNetwork CameraPZ7132192.168.5.110 PZ713200-02-D1-06-65-9E0002D106659E1. Install the "Installation Wizard 2" under the