Vivotek SD8364E/ -M Manual do Utilizador descarregar pdf (Página 18)

Below is a sample procedure using the parapet mount bracket:

1. Determine a hard surface location. Use the alignment sticker to mark the positions

where holes will be drilled for the bracket.

2. Drill 6 pilot holes (10mm in diameter and 5.5cm deep) into the wall, and then hammer

in the sleeve anchors. Note that you should hammer the anchors with hex nuts and

washers on them so that the threaded poles will not be deformed!

528

Parapet wall

3. Install the brackets to wall using the hex nuts and washers from the sleeve anchors.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

Vivotek SD8364E/ -M Manual do Utilizador Página 18