Vivotek FD7131 Manual do Utilizador

EN - 9EnglishBased on the live image retrieved from the camera, adjust the camera lens by doing the following:TW∞NDO NOT over tighten the controllers.

EN - 10Attach the dome cover to camera. Secure the two dome screws with a screwdriver.Finally, make sure all parts of the camera are securely installe

EN - 1EnglishPower off the Network Camera as soon as it is found smoking or smelt unusual.Contact your distributor when such cases happen.Keep the Net

EN - 2Software CDFD7131Warranty cardScrewdriverAlignment stickerScrews and I/O connector Quick installation guidePower adapterPackage Contents1

EN - 3EnglishKeep a note of the MAC address before installing the camera.Network CameraModel No: FD7131Made in TaiwanThis device complies with part 1

EN - 4First, use the supplied screwdriver to detach the dome cover from the camera base. Then, follow the steps below to install the camera; either to

EN - 5EnglishGeneral Connection (without PoE)1. If you have external devices such as sensors and alarms, make connections from gen-eral I/O terminal b

EN - 6Power over Ethernet (PoE)POWERCOLLISIONLINKRECEIV EPARTITION12345PoE switchPOWERCOLLISIONLINKRECEIVEPARTITION12345When using a non-PoE switchUse

EN - 7EnglishNetwork CameraModel No: FD7131Made in TaiwanThis device complies with part 15 of the FCC rules. Operation is subject to the following two

EN - 8For further setup, please refer to user's manual on the software CD.Ready to Use 61. Access to the Network Camera from the Internet.2. Retr