Vivotek IP8335H Guia de Instalação descarregar pdf (Página 7)

EN-6

1. Disassemble the components of the waterproof connector into part (A) ~ (F) as shown above.

2. Remove the rubber stopper from the bottom of the Network Camera and secure the rubber (A)

and screw nut (B) tightly.

3. Open the back cover of the Network Camera.

4. If you have external devices such as sensors and alarms, feed the cables through the waterproof

connector (F --> E --> C --> A+B) as the illustration shown below. Then refer to the pin denition

to connect them to the general I/O terminal block. Note: The recommended cable gauge is 2.0 ~ 2.8

mm.

5. Push the seal (C) into the housing (E).

6. Insert the seals (D) into the empty holes on the seal (C) to avoid moisture.

7. Secure the sealing nut (F) tightly.

8. Tighten the back cover.

9. Remove rubber (G) and feed the cables through the wall mount bracket.

Assembling Steps

(A)+(B)

(E)

(C)

(F)

(D)

(C)

(E)

(F)

(C)

(F)

(G)

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Vivotek IP8335H Guia de Instalação Página 7